You have a car with broken thresholds. There are dents on the thresholds, and perhaps they are completely torn apart. Or you have another option. For example, dents on the hood. In short, there can be many situations. The main thing is that you have the enthusiasm for straightening the car.
Instructions
Step 1
If there are large holes, then they must be pulled out. Put as little putty as possible on the surface so that it does not fly off when driving. In the place where there is a lot of putty, a crack may appear with a slight impact.
Step 2
If it is a closed, deep dent, then you need to drill a hole in the center, and then pull the metal out. You need to pull out with special tools that resemble a long file with tips in different directions. With these branches, the surface is whipped up from the inside, and the dent comes out with a certain effort.
Step 3
Now you need to close the hole that was left after work. To do this, it must be welded using a welding machine. Remember to wear welding goggles. This can only be done on the sills, as there is no need to drill holes in places of the body with thin metal, such as the hood or roof. In such places, dents are knocked out from the inside. The threshold is a rougher place, so it is more difficult to wield and manipulate there. And if there is an opportunity not to cut the metal and not drill holes, then use this option.
Step 4
When you flatten the plane, you will see small dents. To remove them, you need to dilute the putty to cover the surface with one layer. As a result, layer by layer, you will cover the surface of your extruded dent. As a result, you will come to the fact that you will completely putty this place, on which you will not see any flaws afterwards.
Step 5
With such simple actions, you can align the car with your own hands and save very good money! Good luck!
