How To Remove The Rear Seats In The "Prior"

Table of contents:

How To Remove The Rear Seats In The "Prior"
How To Remove The Rear Seats In The "Prior"

Video: How To Remove The Rear Seats In The "Prior"

Video: How To Remove The Rear Seats In The
Video: 2012 NISSAN Xterra - Removing the Rear Bench Seat Cushions 2024, November
Anonim

Lada Priora is one of the latest innovations in the domestic auto industry. The car already has its fans and critics. In defense of their favorite, the owners of Priora say that the car does a good job of transporting bulky goods. You just need to know how to remove the rear seats.

How to remove the rear seats in
How to remove the rear seats in

It is necessary

  • - wrench for 10;
  • - Phillips screwdriver.

Instructions

Step 1

Open the back door of the car. Feel under the seat for the small cushion lock handle. Press the handle, controlling the applied force. Finding a replacement for a broken one will be quite difficult.

Step 2

Gently lift the edge of the pillow to remove it. Walk around the other side of the car and do the same operation so that both ends of the pillow are out of the grooves.

Step 3

Raise and remove the seat cushions from the passenger compartment. The Priora's left rear seat cushion is slightly larger than the right - because of this, it comes out a little more difficult.

Step 4

Now take care of the headrests. Move them to the lowest position, then pull them up with sufficient force until they stop. Then press the release to release the head restraints from the rear seat backrest.

Step 5

Locate the retainer strap on the back of the seat. Pull it up. A car with high mileage and sometimes even a new one can jam the locking mechanism. If this problem persists after several attempts to remove the rear seats, it will be necessary to lubricate the mechanism with lithol. In addition, it happens that the strap cannot be detected due to the fact that the padding of the passenger compartment seats has been made. At the same time, the retainer strap remained inside, behind the cover in the rear seat.

Step 6

Pull up slightly to pull out the rear seat backrest. Pull out the second in the same way. Unscrew the armrest screw attached to the hinge. Then remove the screw of the hinge screwed to the body. Release the hinge and carefully inspect the pillow retainer. If it is defective, disconnect it and replace it with a new one later.

Recommended: