The popularity of Renault Logan cars among Russian motorists is understandable. For a relatively small amount of money, you can buy a reliable, comfortable and roomy car. And if you remove the rear seats, then a fairly large cargo will fit into the Renault "Logan" salon.
It is necessary
- - a wrench on "13";
- - screwdriver.
Instructions
Step 1
Prepare the car to remove the rear seats. Free the rear shelf, pull out the rugs. Gently pull the rear seat cushion forward. Locate and remove the seat clips from the holes in the body. It is possible that the clamps will stick to the holes due to long-term use. In this case, without using any special physical force, swing the clamps in several approaches, pulling the pillow in different directions.
Step 2
Remove the pillow from the car. Locate the two bolts that are located at the bottom, right and left of the rear seat backrest.
Step 3
Proceed to dismantle the backrest. Unscrew the two bolts and raise the backrest by removing its clips from the holes in the rear bulkhead. Move aside the seat belts and pull the backrest out of the passenger compartment. If the belts are faulty, remove them from the mounts. To do this, remove the belt buckle cover and unscrew the bolt securing it. Then use a screwdriver to remove the screw of the upper fastening of the lining on the B-pillar.
Step 4
Pull out the belt bracket. To do this, pull back the facing material. Do not pay attention to the resistance of the clamps, the fasteners are made for an emergency, so it is quite difficult to break them. After the bracket, the seat belt tongue must also be removed.
Step 5
Remove the bottom bracket and rack trim. Pull the traction coil completely out of the body pillar. Pull the vacated rear backrest out of the passenger compartment. It is best to dismantle the rear seats of a Renault Logan car with an assistant.
