How To Open The Doors Of A VAZ Car

Table of contents:

How To Open The Doors Of A VAZ Car
How To Open The Doors Of A VAZ Car

Video: How To Open The Doors Of A VAZ Car

Video: How To Open The Doors Of A VAZ Car
Video: How to open a car door in 5 minutes? Autopsy of any car! 2024, December
Anonim

In the life of a motorist, there are situations when it is required to open the doors of a VAZ car with the help of available tools, without a key. For example, you left the passenger compartment and slammed the door, leaving the keys in the ignition lock, or the battery is dead, and there is no way to open the lock without an alarm.

How to open the doors of a VAZ car
How to open the doors of a VAZ car

Necessary

  • - long stick or brush;
  • - a seal or a rubber chamber with a pump;
  • - planks;
  • - twisted computer pair;
  • - nichrome wire;
  • - pliers;
  • - wipers from the car;
  • - charger or charged battery;
  • - screwdriver.

Instructions

Step 1

Try to open all the doors in turn - maybe at least the trunk will open. Through the open trunk, if possible, climb into the cabin and open the rear door from the inside. If you can't get through, try reaching for the tailgate button with a long stick or, for example, a brush with a scraper.

Step 2

On some VAZ car models, the glass on the rear doors has a backlash and sag over time, so try to widen the gap between the glass and the door. To do this, use a seal or a rubber bladder (pump it up with a pump). It is better not to use a screwdriver or a chisel, as this may cause all the glass to fly out. You can also try to widen the gap between the counter and the door, for this take two thick planks, stick in the gap and squeeze so that you can stick in the eyelet.

Step 3

When you have a gap between the glass and the door, or between the door and the counter, make a loop of nichrome wire or wire extracted from a computer twisted pair. In order to make such a loop, remove the wires from the outer sheath, bend one of them in half and put it back in the braid. At the exit from it, form a loop - you got a noose that you can tighten.

Step 4

Slide the loop or noose through the slot, catch the button that secures the door lock with it, tighten the noose and pull it up. As a last resort, if there is no wire at hand, take the wiper from the car, remove the spoke and bend it with pliers so that a hook forms at the end. Then hook them on the button and pull to open the car door.

Step 5

If the battery in the car is dead and there is no way to open it with the keys, take a charger or battery from another car. Remove the fog lamp and pull out the generator wire (or take it out in any other way), hook the "plus" of the charger to it, the minus can be applied to the body or to the brake disc. As a result, after a while the battery will be charged enough that it can open the doors when the alarm button is pressed.

Step 6

If your car is not very new and you have enough strength, try the next method: Pull the door upward with all your strength and pull it towards you. With enough worn out hinges, the door will open, even if it has not sagged before.

Step 7

Take a powerful screwdriver and drive it into the tailgate lock, then twist. Be careful not to damage the paintwork around the lock. Of course, in this case, after you get access to your car, you will have to change the lock.

Recommended: