For a long time the car has become a part of human life. People cannot imagine life without their own vehicles, as it helps to be at the right time in the right place. However, long and frequent trips are very tiring. Your favorite music will help relieve stress and fatigue while driving. You just need to install a radio tape recorder and speakers in the car.
Necessary
Tools, car speakers, wires, sealant, nails or screws
Instructions
Step 1
Find speakers for your car. Niva is a fairly budget car, so you shouldn't buy expensive speaker models. Also decide on the amount and type of acoustics you buy. If you want the best possible sound quality, buy separate speakers for bass and treble. Models differ from each other also in size. It must be selected based on the vehicle data.
Step 2
Drive the car into the garage. Apply the parking brake. Open the hood, take out the spare wheel and remove the negative terminal from the battery. This is to prevent short circuits. Open as much as possible the door into which the column will be installed. You need to buy or make your own podium - a special small box in which the speaker will be located. Carefully remove the door trim. Attach the podium to its bottom with nails or self-tapping screws. Place a sealant between the podium and the paneling to prevent them from making a grinding noise when vibrated with music.
Step 3
Lead the wires from the radio so that they go out to the doors. There is a technical opening between the door and the wing. Through it and you need to thread the wires, having previously attached a rubber gasket to the sharp edges. Leave some wire so that the door can open and close until it stops. Connect the wires to the speaker and replace the casing. Do the same for the other door. To install the speakers at the back, you need to cut them into the shelf. Route the wiring either through the center tunnel or under the floor sheathing.
