You can talk forever about the delights of a car with an automatic transmission, but when it comes to a dead battery, its advantages over other cars seem to immediately fade into the background. To start a car with automatic transmission, you need to know some subtleties so as not to break your "favorite".
It is necessary
Starting-charger, cigarette lighter wires, towing rope, elastic strap, set of box and socket wrenches, simple and Phillips screwdrivers, one of those who admired your car the day before
Instructions
Step 1
The most effective and reasonable way to start a car equipped with an automatic transmission with a dead battery is the so-called "cigarette lighter". Why do you need a donor car with a working battery and wires for lighting. The donor car should be positioned so that the locations of the batteries of your car and the donor are as close as possible. We connect the leads of the batteries of both cars with wires according to the polarity, start the donor engine and wait a few minutes so that the battery of your car can recharge a little. After a successful start, we remove the wires. You can go.
Step 2
A variation of starting the car by the "lighting" method can be considered starting from a starting-charger. If you or a friend of yours has such a device, you will definitely start the engine; in addition, for this you will need access to a 220 volt outlet. Connect the leads of the charger to the terminals of the battery, then plug the device into the mains. Wait a few minutes, now you can start. You are even more fortunate if the starter-charger is a self-contained, in fact a portable battery. It can be used to start the engine without access to the AC mains.
Step 3
If none of the above is found in the vicinity, you can start the engine mechanically. On the side opposite to the gearbox on the engine, there are drive pulleys for auxiliary units (generator, air conditioner, power steering pump, etc.) driven by belts. If there are several belts and the extreme one does not set the generator in motion, then we can safely remove it. We take an elastic belt and wind it tightly around the engine crankshaft pulley. We transfer the gearbox to the “parking” position, turn on the ignition. It will take an effort to spin the engine, perhaps not even one person, but the result will please.
Step 4
If the belt is still one, and it sets the generator rotor in motion, it remains to start the car from the "pusher". To do this, using a towing cable, we attach the car to the pulling machine, the gear selector to position "2", after starting the engine, move the selector to the "N" position and give a signal to stop the driver of the pulling car.
