How To Remove Jacks Mode

Table of contents:

How To Remove Jacks Mode
How To Remove Jacks Mode

Video: How To Remove Jacks Mode

Video: How To Remove Jacks Mode
Video: How to remove broken rca jack 2024, December
Anonim

Valet mode is the service mode of the car alarm. In it, all security functions of car alarms are completely disabled. This mode is necessary if, for example, you need to leave your car in the service for repair.

How to remove jacks mode
How to remove jacks mode

It is necessary

  • - alarm control panel;
  • - car alarm operation manual.

Instructions

Step 1

Take the instruction manual, go through all the sections. There you can probably find a description of how to disable this function. If such information is not there, or for some reason you cannot use the manual, then it does not matter. And despite the fact that the process of disabling the Valet mode is individual, nevertheless, all security systems have a similar procedure for disabling this function. But it is worth noting that it will take you a little more time than if you performed this operation according to the manual.

Step 2

First sit in your car and turn on the ignition, then after 5 seconds turn it off. At the same time, try to observe this particular time interval, since in case of failure you will have to repeat this operation. Then press and hold the Valet switch for 10 seconds. This switch can be found on the signal receiver, which is usually located under the steering block of the machine.

Step 3

Please note that after these actions, the siren of the security system should give from two to five short signals. After that, the light-emitting diode will go out, and the side lights of the car will flash several times. After that, the Valet service mode will be disabled and the alarm will operate normally.

Step 4

Make sure the remote control has buttons and switches before disabling this mode. If you cannot find them, they are most likely labeled differently. Then you will have to contact the service center for advice.

Step 5

Use the alternative option to remove the Valet mode. This can be done remotely using the security control panel. To do this, you need to get into the car, turn on the ignition and turn it off after 5 seconds. Then press the buttons with the speaker and the open lock and hold them for 15 seconds. The siren will have to emit two to five beeps, the parking lights will flash several times, and the alarm LED will turn off.

Recommended: