The first question that arises before the car owner after purchasing a VAZ car or even any other is the provision of anti-theft measures. And if, as a rule, there are no problems with the purchase of a car alarm, then certain difficulties sometimes arise with its installation.
It is necessary
Car alarm - 1 set
Instructions
Step 1
After you ask for help in installing a car alarm on your brand new VAZ in a specialized service, the electronic part specialists will be happy to help you carry out the work for a certain amount of money, which sometimes exceeds the cost of an electronic security kit.
Step 2
For those who are somewhat constrained in funds, there is only one way out - to install the anti-theft system on their own. And this has its own advantage. The fact is that service specialists install equipment in cars according to a standard scheme. Consequently, in the event of an encroachment on private property, there will be no secret for criminals about where exactly the car alarm units are located in the car. In this case, their search in order to disable the alarm will be greatly facilitated.
Step 3
A typical anti-theft alarm kit consists of the following components:
- system unit, - six-tone siren, - shock sensor, - starter cutout relay, - forced switch of the electronic unit of the "Valet" type.
Step 4
It is better to combine the installation of equipment with work to improve the sound insulation of the car interior, when the dismantling of the front panel is required.
Step 5
You need to start with the preparation of electrical wiring. Cutting wires of the required length, as well as equipping the ends of the wires with the necessary terminals and connectors (see the instructions for the car alarm) - this is the first thing to do.
Step 6
Let us assume that all the operations of the preparatory stage have been completed. Further, the placement in certain places and the installation of system components continues.
Step 7
The first to install and secure with self-tapping screws is the electronic alarm control unit. After it, a starter cut-off relay, a "jack" switch and a shock sensor are mounted, which must be fixed on a rigid base, which excludes damping of the vibration amplitude.
Step 8
Then an alarm horn is installed under the hood, after which all the elements are connected according to the scheme (see the instructions), which should include: hood and trunk lid locks, as well as the mechanisms for opening all doors (without exception) are protected.
Step 9
The wiring diagram is detailed in any documentation accompanying the security system kit. Dealing with it is pretty easy.
