All the nuances of installing an alarm on a VAZ - a step-by-step sequence of connection, wire colors, blocking, the value of the Valet button. Connection of electric drives, limit switches, sirens.
It is necessary
- Screwdriver
- Pliers
- Side cutters
- Set of wrenches
- Drill and drill set
- Dial-up or tester
- Wires
- Insulating tape
Instructions
Step 1
The first step of self-installation is to install the LED that comes with the alarm. The LED is installed on the torpedo in a conspicuous place closer to the glass. Find a convenient hidden place for the alarm unit under the torpedo: on the right, left or in the middle, depending on the car model.
Step 2
Using a dial-up or a tester, find the wires going to the turn signals, ignition, + 12V, door limit switches (door open and close buttons), and the central lock. If the central locking in this model is not provided, then it is necessary to remove the door trim and install the electric drive and connect it to the alarm unit according to the instructions. Electric actuators can be installed on all four doors. The wires for the limit switches and turn signals are in a harness in the threshold leading to the trunk. If the car does not have hood and trunk limit switches, install them additionally - drill next to the lock on the inside. The additional limit switches themselves, as a rule, come complete with an alarm.
Step 3
The siren is installed under the hood in a dry place in the far corner. It is drilled, the black wire is shorted to ground, and the red wire goes to the alarm unit. The connection points of the wires are wrapped in black electrical tape. If you want the connections to be invisible at all, then the wires can be soldered. Lock the engine to provide your vehicle with extra theft protection. The main admissible blockings are blocking of ignition, starter, fuel pump. Locking can be done in the hood or under the torpedo. The mass (negative) wire is connected to the car body, and the positive (red or pink) wire is in a bundle under the torpedo.
Step 4
There is a Valet button in the alarm set, with which the alarm is programmed and turned off. It is advisable to install it in a secret, but personally accessible place for you. It is used if the alarm has broken down, you want to change the alarm settings or disable it altogether, leaving only the central locking function. All settings with the Valet button are made according to the instructions for the selected alarm model.
