All motorists dream of maximum protection against theft for their "swallow". In this case, it is difficult to entrust the installation of the security system to a dubious car service, and large dealerships announce inflated prices for the installation. If you have basic knowledge of the car and electrics, you can install a simple alarm yourself.
It is necessary
- Drill
- Screwdriver
- Side cutters
- Tester
- Insulating tape
Instructions
Step 1
Install the LED in a conspicuous place near the glass on the dashboard.
Step 2
For the alarm unit, find a convenient and hidden place under the dashboard. The further you hide the alarm unit, the less chances that it will be found and turned off.
Step 3
With a tester, find the wires going to the turn signals, ignition, + 12V, door limit switches (door open and close buttons), and the central lock. If the central locking in the car is not provided, then remove the door trim and install the electric drive. Connect it to the alarm unit according to the instructions. Electric drives can be installed on all four doors.
Step 4
The wires of the limit switches and turn signals are in a bundle in the threshold leading to the trunk. If the car does not have hood and trunk limit switches, install them additionally.
Step 5
Install a siren under the hood in a dry far corner. Drill it down, short the black wire to ground, and connect the red wire to the alarm unit. Either wrap all wire connections with black electrical tape or solder.
Step 6
The main safety of the car is provided by interlocks - starter, ignition or fuel pump. To block it, you need to find a wire leading, for example, to the ignition. They bite the wire, "cut" the wire from the block into it. The color of the blocking wire is indicated in the instructions for the selected alarm.
Step 7
The alarm kit comes with a Valet button, with which the alarm is programmed or turned off. The button must be installed in a secret, but personally accessible place for you. It is used if the alarm has broken down, you want to change the alarm settings or disable it altogether, leaving only the central locking function. All settings with the Valet button are made according to the instructions for the selected alarm model.
Step 8
After installing the Valet button, you can start programming the alarm functions. You can program only the functions you need or expand the standard capabilities of the security system. All programming is done strictly according to the instructions for this alarm model.
