How To Install The Alarm Yourself

Table of contents:

How To Install The Alarm Yourself
How To Install The Alarm Yourself

Video: How To Install The Alarm Yourself

Video: How To Install The Alarm Yourself
Video: How to Install a Security Alarm System | This Old House 2024, November
Anonim

Installing a burglar alarm is the business of every car enthusiast. But those who do not want their car to be stolen or damaged will definitely take care of the security system. If you do not want to spend money and are confident enough in your abilities, then try to install the alarm yourself.

How to install the alarm yourself
How to install the alarm yourself

It is necessary

  • - car alarm;
  • - terminals for ground;
  • - terminals for standard connectors;
  • - crimp terminals "+" and "-";
  • - wire and 2 low-current diodes;
  • - plastic clamps;
  • - multimeter;
  • - clamps-ties (plastic) and electrical tape;
  • - soldering iron;
  • - soldering acid;
  • - Screwdriver Set;
  • - wire cutters and pliers.

Instructions

Step 1

If you want to install an alarm on a car without removing the panel, then place the unit under the soundproofing of the engine compartment in the area of the pedal assembly. Place the blocking relay near the ignition switch, and attach the shock sensor to the steering column using plastic clips

Step 2

Remove the dashboard. Screw the block to the walls of the engine compartment. The blocking relay can be placed in the area between the branches of the air duct (right and left). The second way to install the alarm involves removing the panel and the optimal solution for the placement of its components. Any component of the alarm system must be freely located in the passenger compartment or body of the car.

Step 3

Place the siren itself under the battery pad. Place the end of the hood (on the right) at the turn signal, and the end of the trunk, try to install it next to the lock. After you place the blocks, start routing the wiring. Be sure to spread the ends of the hood and trunk towards each other. Combine all wires in this sector with standard wiring using electrical tape.

Step 4

Install the alarm frame and the shock sensor last. The switch for the alarm system must be installed so that it is invisible, but at the same time easily accessible. After completing all the settings, start programming the alarm.

Recommended: