How To Tint Windows

Table of contents:

How To Tint Windows
How To Tint Windows

Video: How To Tint Windows

Video: How To Tint Windows
Video: WINDOW TINTING: HOW TO TINT WINDOWS (FOR BEGINNERS) 2024, December
Anonim

Not so long ago, car windows were tinted only in special services. This service cost quite a lot of money. At the moment, anyone can tint the windows of a car, you just need to have perseverance and accuracy.

How to tint windows
How to tint windows

It is necessary

So, you decided not to contact a specialist and want to tint the car windows yourself. To do this, you need to stock up on quality materials. The main material is metallized film. In addition to the film, you will also need a small amount of a well-soaping detergent, a spray bottle and a large eraser

Instructions

Step 1

The process of tinting car windows is divided into several stages. First you need to remove the glass of the car, except for the rear and front. The rear window is tinted on the spot. It needs to be cleaned well. There are special cleaning agents available. After cleaning the glass, using a spray bottle, moisten it well with soapy water, which was prepared in advance. Apply a film to the damp glass, and then smooth it well with an eraser. Excess moisture can be removed with a regular hair dryer.

Step 2

Other glasses need to be measured well. After that, add five centimeters to the measurements. Now a lot and start cutting the tint film. The glasses must be washed well. This is best done in the bathroom. Due to the high humidity, the film will easily and quickly roll over the surface.

The glass is washed. You can start working with the blade. The blade just needs to be driven over the glass, thereby removing the remaining contamination. We take the film itself and apply it to the glass with the adhesive side. Please note that it is at this moment that both the film and the glass should be abundantly moistened with soapy water.

Step 3

After the film is connected to the glass, you need to remove excess moisture that is in the gap between the surfaces. Movements should be measured and accurate. The eraser needs to be driven from the center of the glass to the edge. After a while, the film will dry out. At this point, you can start trimming the edges. This is best done with a sharp clerical knife.

Recommended: