Unfortunately, not all types of radio tape recorders have standard ISO connectors, and more often you need to connect the radio tape recorder yourself. This process must be taken quite carefully, since the polarity reversal will carry a number of problems, up to and including a malfunction of the device.
Instructions
Step 1
Remove the frame from the radio housing. Install the bezel in the place provided for the radio, they are usually of a standard size. Bend the petals on the frame with a screwdriver so that it is securely fixed in the hole in the case.
Step 2
Disconnect the battery. The yellow wire (BAT) is responsible for the full memory of the device settings, connect to a constant plus. The red wire (ACC) provides the main power, connect to the positive terminal of the ignition switch. In some models, there is already a separate wire in the block. It can be determined using a tester.
Step 3
Black wire is ground or minus. Connect it to the body, there is always negative polarity. Blue wire (REM) - positive connection. This is access to the active antenna and the remote activation of the amplifier. If there are several amplifiers, then install an additional five-pin relay.
Step 4
For the illumination to work, connect the radio tape recorder with an orange wire to the terminal where a plus appears when the dimensions are turned on. Yellow-black lead (sometimes color can be changed) (MUTE) - connect if you have a Hands - Free kit. In the absence of one, this wire does not need to be connected anywhere.
Step 5
White or white / black (variations possible) connect to the left front speaker. Gray or gray-black connect to the right front speaker. Connect green or green / black to the left rear speaker. Connect purple or purple-black to the right rear speaker.
Step 6
Insert the radio into the slot until it clicks into place. Check all the functions of the radio. Listen to the sound quality. If it is not satisfactory, you may need to adjust the sound parameters in the device settings.
