How To Make A Bumper For A UAZ

Table of contents:

How To Make A Bumper For A UAZ
How To Make A Bumper For A UAZ

Video: How To Make A Bumper For A UAZ

Video: How To Make A Bumper For A UAZ
Video: УАЗ "Головастик" Силовой бампер своими руками. 2024, November
Anonim

The front bumper of a UAZ car is designed to damp the force of an impact during a collision of the car with an obstacle, thus protecting the supporting structures - the body and frame. Therefore, the bumper should be strong, but not overly rigid. These factors must be considered when designing the specified accessory.

How to make a bumper for a UAZ
How to make a bumper for a UAZ

It is necessary

  • - "Bulgarian",
  • - electric drill,
  • - clamps,
  • - welding machine.

Instructions

Step 1

Despite the fact that the standard bumper of cars produced by the Ulyanovsk Automobile Plant does not inspire confidence in many, it must be remembered that it is manufactured in full accordance with engineering calculations, which, unfortunately, did not provide for the installation of additional equipment on it, for example, a winch.

Step 2

Before starting the practical manufacture of the specified accessory, the master should take into account that the design of the bumper will directly affect the appearance of the car as a whole.

Step 3

Taking into account all of the above, a sketch of the project of the future product is made on paper, assuming that the bumper will be streamlined on the sides and in the lower part, and the upper part is calculated taking into account the site for placing an electric winch.

Step 4

After taking the necessary measurements, a finished project is created.

Step 5

As a rule, the front bumper for an off-road vehicle is made of metal. Therefore, we propose to consider this particular option.

Step 6

The details of the project, made on a Whatman paper in full size, are transferred to the metal, after which blanks are cut from it, in which all the necessary holes are made.

Step 7

Further, all the parts are laid out on the workbench, where the final adjustment of the blanks is made, and then, using DC electric welding (or hardware), they are connected into a single structure.

Step 8

At the end of welding, all seams are cleaned with a grinder, the surface of the bumper is putty and painted. The finished product is mounted to the front brackets of the car.

Recommended: