In most cases, replacing various VAZ 2110 sensors does not require special equipment and professional skills. The process of replacing most of the sensors is a fairly simple procedure and may well be carried out by the car owner with his own hands.
Necessary
- - key for 22;
- - key for 21;
- - key for 13;
- - tester.
Instructions
Step 1
Replacing the speed sensor VAZ 2110 Disconnect the electrical connector on the sensor. To do this, it is necessary to slightly squeeze the metal "ears". Unscrew the sensor by turning it counterclockwise. If you cannot do it by hand, use the key 21. Take a new speed sensor and install it on the drive. Installation should be done in reverse order.
Step 2
Replaced the sensor of insufficient oil level in the engine VAZ 2110 In order to make this replacement, you need to disconnect the wire from the sensor and unscrew the mounting bolt using a key 21. Slightly shaking the sensor, remove it from the socket in the cylinder block. This should be done very carefully so as not to damage the float. Seal the sensor body with an aluminum ring. Install a new sensor.
Step 3
Replacing the knock sensor VAZ 2110 Single-contact batteries and disconnect the sensor from the block with wires. Unscrew the sensor mounting nut using a 13 key, remove the washer. Disconnect the transducer from the stud Check the transducer. To do this, connect its contact to the body of the tester. Take a frame made of soft metal. Measure the voltage pulse by tapping the barrel against the threaded part of the knock sensor. It should be noted that for a knock sensor in working condition, the voltage pulse should vary in the range from 40 to 200 mV, depending on the intensity of the blows. Replace the sensor if necessary. Installation of the sensor must be carried out in the reverse order.
Step 4
Replacing the oxygen concentration sensor VAZ 2110 To replace the lambda probe, you must disconnect the wire from the minus terminal of the battery. Pry off the plastic latch and disconnect the sensor block from the wire harness. Unscrew the sensor from the front pipe. Take a new sensor and install it in the reverse order.
