The fogged rear window of a car brings its share of discomfort to driving. Especially during its operation in the autumn-winter period, when the ambient temperature approaches zero, and the atmosphere is saturated with moisture. In addition, the impairment of the rear visibility of the traffic situation lowers the level of safety.
Necessary
conductive adhesive with stencils
Instructions
Step 1
First of all, it is necessary to find out the reasons for the deposition of condensation on the surface of the rear window. For this purpose, a control light or an avometer is used, with the help of which the presence of voltage at the contacts of the heating element in the specified place is determined.
Step 2
If, as a result of the check, a positive result is obtained, then later, during a visual inspection of the glass, an area is revealed in which there is a break in the heating circuit.
Step 3
Having determined the place of repair, the protective film is removed from the stencil supplied with the glue tube, and it is glued to the glass so that the damaged section of the chain is in the center of the slot of the stencil.
Step 4
reception:
1. The required amount of glue is squeezed out into the slot of the stencil and mixed there;
2. a minute after applying the first, the second layer is applied, but not mixed, but simply applied on top.
Step 5
After about ten minutes, which is enough for the adhesive to cure, the stencil is removed from the glass, and the car with the re-heated rear window is ready for further operation.
