The Russian car market is developing rapidly, and more and more patriotic motorists appear who choose a domestic manufacturer. However, during the pre-sale preparation of Lada Priora cars, the manufacturer may look at some points. For example, the standard alarm may not be activated for you.
It is necessary
- - car Lada Priora
- - car manual
- - training and working keys
Instructions
Step 1
In a Lada Priora car, the immobilizer is read directly from the key. You can activate it yourself. Refuel about 10 liters of gasoline before the procedure. This must be done in order not to get confused in the sound signals of the car.
Step 2
Close all vehicle doors. Switch on the ignition with the learning key. Wait 6 seconds. Switch off the ignition. Indicator of the correctness of the actions performed: a rapidly flashing lamp (at least 5 times per second). Pull out the learning key.
Step 3
Immediately insert the working key into the lock and turn on the ignition. You have about 6 seconds for this until the lamp stops blinking. Three beeps should sound. With the ignition on, wait for two more signals, then turn off the ignition.
Step 4
Within 6 seconds, remove the key from the lock and reinsert the training one by turning on the ignition. When turned on, you should hear three beeps. Without switching off the ignition, wait for two more signals (about 6 seconds).
Step 5
After turning off the ignition, do not remove the key from the lock. Wait for a single beep. The lamp should blink twice as fast. At this moment, turn on the ignition again with the same key. Wait 2-3 seconds. Switch off the ignition. After a maximum of five seconds, you will hear three beeps and the light will stop flashing. Do not turn on the ignition for at least ten seconds.
Step 6
It may be necessary to resynchronize the immobilizer because the controller may prevent the engine from starting. To do this, turn on the ignition with the working key, wait 6 seconds. If the light blinks 1 time per second (error condition), turn off the ignition for 10 seconds. Then - turn it on again, the light should not blink.
Step 7
If three seconds after turning on the ignition with the operating key, the light is constantly on, then the procedure must be carried out from the very beginning.
