Tinted windows in the car protect the driver and passengers from sunlight and prying eyes, give the car a stylish and modern look. You can stick the tint film with your own hands, saving money on a trip to a car service.
It is necessary
- - scissors;
- - film;
- - ruler;
- - scapula;
- - a rag;
- - soap solution.
Instructions
Step 1
Prepare glass for tinting. Remove them carefully, wash and wipe with gasoline. There should not be the slightest dirt, dust, streaks. Otherwise, after gluing, ugly bumps may form under the film. Dry the glass. You do not have to take them out, but applying the film will require a lot of dexterity.
Step 2
Cover the table with oilcloth, making sure that there is no dust and sand on it. Make a soap and water solution. Cut the film to the desired shape, leaving an allowance of a few millimeters. Place the glass on the table.
Step 3
Apply soapy water to the glass. It is best to use a spray bottle to achieve uniformity. Carefully peel off the protective film from the piece of tinting. Wet the adhesive side of the tint film with the solution.
Step 4
Gently smooth the film over the glass with a spatula or rag. Do not press too hard - the film may tear. Smooth from the center of the glass to the edges. The film must adhere tightly to the glass, the slightest bubbles and irregularities are unacceptable. If air gets under the film, it must be squeezed out and a good fit is achieved. Cut off the edges of the film. Leave the glass to dry for a few hours. Check if the film is holding well. Install the glass on the car.
