Fuel consumption in a car, the dynamics of its acceleration, as well as the level of CO directly depend on the setting of your carburetor. "Ozone" is a carburetor that requires a special setting. You can make it yourself.
Necessary
- - screws of the quality and quantity of the mixture;
- - device for measuring CO;
- - screwdriver.
Instructions
Step 1
First, check that the spark plugs are in good condition, since the Ozone carburetor can only be adjusted with working spark plugs. Then warm up the engine so that the coolant temperature is at least 80 degrees Celsius. Then open your carburetor choke fully. Once done, install the adjusting screws. To do this, tighten the quality screw completely, and then unscrew it by 2-2.5 turns. Turn the screw for the amount of mixture 1, 5-2 turns from the position at which it begins to act on the lever, which is attached to the axle by the throttle valve.
Step 2
Set the lowest possible speed for the crankshaft of your engine by unscrewing the screw if the position of the quality screw is arbitrary. Then rotate this screw in the right direction to achieve the maximum speed of the vehicle's crankshaft. Do not move the throttle column while performing this step. Then set again the minimum speed for the crankshaft by turning the stop screw. The frequency should be stable in this case. According to statistics, after two or three such operations, the motorist can find the position of the screws for adjustment, which will be completely suitable for the car. This position will provide the desired quality and quantity of the mixture, which will lead to economical operation of the engine and, accordingly, low fuel consumption.
Step 3
Check how correctly you have adjusted the mechanisms. Do this with a sharp opening, and then when the throttle valve is closed. In the event that the engine continues to run, you can be sure of the correct adjustment. If not, try the operation again. Install a new plug after adjusting so as not to spoil what you have done.
