To increase the spark, improve the efficiency of the ignition system. To do this, remove the resistor to reduce radio interference, put copper high-voltage wires, increase the gap between the electrodes. Install a spark amplifier if necessary. If the car has a contact ignition system, change it to a contactless one.
Necessary
copper high-voltage wires, a set of keys, a spark amplifier, a kit for installing a contactless ignition
Instructions
Step 1
Most modern candles use special resistors to reduce electromagnetic interference. If you install candles without resistors, then the amount of released energy will increase by 50%. Replace all high voltage wires with copper wires. By reducing the resistance of the system, the energy on the spark plugs will increase. Increase the interelectrode distance and test the candle in a special pressure chamber. Select the largest gap at which a stable spark is observed at a pressure of 10 kg / cm². In this case, the duration of the spark remains the same as it was, and its energy, and hence the power, increases. But this increases the load on high-voltage wires, so their quality must be high. This will increase the energy of the spark by approximately one and a half to two times.
Step 2
To increase the energy, a special spark amplifier is used, which is mounted directly on the candle. This device consists of a capacitor and two connections, one of which is attached to a candle, the other to a high-voltage wire. During the operation of the device, there is some delay in the discharge of the candle, due to the charging of the capacitor. In this case, the amplitude of the current increases significantly, and with it the temperature of the spark during the discharge.
Step 3
If a contact (currently outdated) ignition system is installed on the car, replace it with a contactless one. Purchase a standard kit consisting of a high voltage coil, Hall sensor, commutator, and a set of wires. Install the high voltage coil under the hood, replace the "slider" with a Hall sensor, and install the high voltage wires. Observe the ignition timing markings on the crankshaft. Replace the spark plugs with new ones and connect all the elements with wires according to the diagram. Set the ignition timing.
