How To Remove A BMW Radio

Table of contents:

How To Remove A BMW Radio
How To Remove A BMW Radio

Video: How To Remove A BMW Radio

Video: How To Remove A BMW Radio
Video: Easy Radio And Climate Control Removal BMW 1-series 3-series E90 E92 E81 E82 E87 E88 2024, November
Anonim

Every year, car radio manufacturers present new models and modernize old ones. Based on this, the BMW owner has a desire to replace the outdated radio tape recorder with a new model, but there is no knowledge and experience in self-installation. Often the owner cannot even remove the head unit. The factory-installed radio or radio has different mountings. Before removing the radio, be sure to disconnect the ground wire (negative) from the battery.

How to remove a BMW radio
How to remove a BMW radio

It is necessary

  • Screwdriver Set.
  • Specialized keys for removing the radio.
  • Strippers.

Instructions

Step 1

The factory-installed slide-out radio (radio) can be quickly removed or installed only with a special key. Purchase such a key from a specialized store, if it was not included with the radio when purchasing. The quick release can be recognized by two or four holes in the front panel. Depending on the power and the number of loudspeakers in the boot, an additional amplifier may be located under the trim on the left-hand side.

Step 2

To remove the "Bavaria / S" type radio, remove both control knobs and decorative washers under them. Use a narrow screwdriver to bend up the retaining springs. They are located on the axis of the handles. Then remove the front panel and insert the tabs on the tabs on the back of the panel into the grooves. Please note: the pressed-out tabs of the fixation springs should be on top and point to the front side of the panel. Then unscrew the screws located near the axis of the control sticks and remove the fastening brackets. Remove the radio from the dashboard. On the back of the radio, find and disconnect the connectors for the ground, battery (B +), speakers, antenna and its electric drive (if any).

Step 3

To remove a radio type Bavaria Cassette III or Europa Digital with a retractable mount, find the two holes on the front panel on the left and right. Insert the pullers into these holes. If there are no such holes, remove the control knobs and the panel, and then insert the pullers into the vacant holes. While pushing the strippers towards the outside of the panel, release the tabs. Then remove the radio tape recorder from the dashboard, while avoiding distortions. Before disconnecting the speaker connectors, mark the left and right channel connectors with something. For example, tape of different colors. To remove the pullers, press the spring clips with a small screwdriver.

Step 4

To remove the "Bavaria Electronic" radio tape recorder perform in the following order. Use a narrow screwdriver to gently bend the front panel. Remove the handle. Find the clips to the left and right of the panel and insert the keys to remove the radio tape recorder into them. While pressing the keys towards the inside of the panel, remove the radio. Disconnect all connectors on the back of the radio, including the antenna cable.

Recommended: