The life of road users is full of surprises, especially when traveling in a car. Even with an extremely careful driver who complies with all the requirements of the "Rules of the road", a nuisance can happen on the way. For example, some absent-minded colleague will not be able to stop in time and smash the taillight of the car in front.
Necessary
a 10 mm spanner
Instructions
Step 1
The lack of light signaling of the rear lights, when the direction indicators and brake lights do not work for the car, create a stressful state for the driver during uncomfortable driving of a faulty car.
Step 2
Therefore, the desire of the car owner to quickly repair the rear lights of the car is quite justified.
But before purchasing a new set in the retail network, the faulty lights must be dismantled from the rear panel of the car body and their troubleshooting must be performed.
Step 3
To achieve the set task, the luggage compartment is opened in the car, and from the inside on the rear panel, two nuts are unscrewed, made of plastic and securing the protective cover for the rear lamp. Since the bus connected to the circuit board is rather thin and easily breaks off if you carelessly handle the equipment being repaired.
Step 4
At this stage, the latches are squeezed out, and the circuit board is dismantled, on which the sockets for the light signaling lamps are located. After a careful examination of the conductive tracks, in order to detect a break in them, a decision is made on the further use or on replacing (in case of defects) the rear lamp circuit board.
Step 5
To remove the glass with a reflector from the body, it is necessary to unscrew the four nuts securing the lamp from the inside of the luggage compartment with a 10 mm wrench. To replace the dismantled lamps, their parts are purchased from the car dealership either individually or as an assembly. And it makes no sense to spend money on an extra, knowingly faulty spare part.
