How To Weld The Trunk

Table of contents:

How To Weld The Trunk
How To Weld The Trunk

Video: How To Weld The Trunk

Video: How To Weld The Trunk
Video: How to PROPERLY Repair a Rust Hole in your Car or Truck (DIY for Beginners) 2024, November
Anonim

To transport various goods, when there is not enough space in the luggage compartment, then motorists install an additional device on the roof of the car designed to accommodate oversized items. Most often, they are forced to operate light vehicles as freight: self-builders and merchants.

How to weld the trunk
How to weld the trunk

Necessary

electric welding machine

Instructions

Step 1

The roof rack, designed for installation on the roof of a passenger car, greatly facilitates the solution of the issue of the delivery of goods for various purposes. And the mentality of domestic motorists is such that everything must be transported in one trip. If everything you need can be placed at once, then why wind up extra kilometers on the odometer? This is the line of thought of most drivers.

Step 2

Excessive load on the trunk and roof of the car, associated with excess weight, is considered a secondary factor and the hope in most of these cases among our citizens, as a rule, on the all-powerful Russian: "maybe, let it blow."

Step 3

And when the trunk, unable to withstand an irresponsible attitude towards itself, nevertheless breaks down, then first of all "compliments" go to its manufacturer. The flow of abuse in this situation helps the unlucky owner to “let off steam” and calm down. Having come to his senses, he begins to think with a cool head how to restore a failed device.

Step 4

In cases where the work is planned to be performed independently, then an electric welding machine will be required, preferably a carbon dioxide semiautomatic device. In order to carry out refurbishment, the trunk is dismantled from the roof, after which its damage is examined.

Step 5

If the cross member has burst, then it is necessary to make lining for it in the form of a piece of tube of the same diameter, cut lengthwise into two parts by a "grinder", which are then welded in such a way that the burst is placed in the middle of the superimposed repair blanks.

Recommended: