How To Start A Subaru In Cold Weather

Table of contents:

How To Start A Subaru In Cold Weather
How To Start A Subaru In Cold Weather

Video: How To Start A Subaru In Cold Weather

Video: How To Start A Subaru In Cold Weather
Video: #СУБАРУПОГОДА 2024, November
Anonim

Warming up the car is necessary for the engine to work better during the cold season. For Subaru owners, the question of how to reduce the warm-up time of the car without losing efficiency is also becoming relevant.

How to start a Subaru in cold weather
How to start a Subaru in cold weather

Instructions

Step 1

If you have a carburetor installed on your car, then during warming up, pull the air intake knob to the maximum length and wait. At this time, the car starts to work at increased speeds, which leads to its early warming up. Remember that it is quite difficult to start a carburetor engine without suction in winter.

Step 2

No suction is provided for injection engines. Therefore, there is nothing left but to start the engine, slightly press the gas pedal and wait until the engine warms up to the desired temperature. However, in very severe frost, high revs are held very poorly.

Step 3

Construct a kind of suction for the injection engine. Indeed, at the time of start-up, such a motor works on the principle of a carburetor with a choke handle. To carry out your plan, open the hood and find the throttle cable. On the side of it, in the direction of travel, there is an iron strut, a jumper.

Step 4

Unscrew it carefully and attach an electromagnet to it, which is rated for a voltage of about 24 volts. Attach the spool frame to the spacer, then attach a cable to the electromagnet, and to the other end - an attachment for the throttle cable, which will also allow you to change the length of the cable stretched by the spool. This will make it possible to adjust the number of revolutions during warming up.

Step 5

Cover the coil with a layer of hot melt glue to protect it from exposure to dust, dirt, liquids. Attach the spacer to its place and install a button in the car interior that will activate the mechanism. Remember that after turning the key in the ignition lock, you must slightly press the gas pedal for the electromagnet to work.

Step 6

Then press the button and wait, the coil will maintain a constant number of revolutions on its own. At this time, you can clean the car from snow and ice, without thinking about the fact that the speed will drop and the engine will warm up for a long time.

Recommended: