How To Start An Injection Engine In Frost

Table of contents:

How To Start An Injection Engine In Frost
How To Start An Injection Engine In Frost

Video: How To Start An Injection Engine In Frost

Video: How To Start An Injection Engine In Frost
Video: Modern electronic fuel injection system 2024, December
Anonim

The good thing about a car is that in winter you are protected from severe cold weather. The heating system of your car helps you with this. However, every winter morning, you can see tons of car owners running around their cars, trying in vain to start them. How can you start an injection engine at negative temperatures.

How to start an injection engine in frost
How to start an injection engine in frost

It is necessary

Owner's manual for your car, wires with crocodiles, battery charger

Instructions

Step 1

It should be noted right away that leaving the car in the cold for more than one night is a direct way to doom yourself to big problems in the future. If you do not plan to use the car in the next few days, then do not be lazy and take out the battery so that it does not empty out in vain. Indeed, with a fully planted battery, the chances of getting into frost are zero. Do not start the car right away. Turn the ignition key to the first cut to turn on all electronics. The on-board system will carry out a check procedure and correct any errors. You can also briefly turn on the hazard warning lights or fog lights. This will allow the battery to warm up slightly. The electric pump will also work.

Step 2

Now depress the clutch fully and try to start the car. If the engine is running, do not release the clutch immediately. Let it run a little more and then release the clutch smoothly. Never touch the gas pedal! The engine will set itself to a higher idle speed, which will help warm up the system. It is necessary to wait until the engine temperature reaches normal values and the rpm drops. Never turn on the air conditioner immediately after starting the engine.

Step 3

If the engine does not start, then you need to look for the cause. It usually consists of a seated battery. In this case, you need to either get the battery and charge it at home, or "light" it from another car. It is also worth pumping a little gasoline, for this, before trying to start the engine, press the gas pedal several times until it stops. This will supply a new batch of fuel. It should be borne in mind that you should not immediately move, since the car has completely frozen pads and brakes, so the first five hundred meters you need to drive very slowly and carefully, bypassing all potholes and not raising the engine speed above 2000 - 2500 rpm.

Step 4

Installing a temperature control system in your car will greatly facilitate starting the engine. For example, "webasto". Installing such a system will cost you several thousand rubles, but you can save on time and gasoline, which you usually spend on warming up.

Recommended: