Most motorists are aware of the problems they may face during the winter. Frost has a very negative effect on the engine of any vehicle, so that in the morning it seems impossible even to start it. This is due to the freezing of oil in various car systems. So it is necessary to start the injection machine very carefully.
Instructions
Step 1
Among the main reasons that prevent starting a car on a winter morning, it is worth highlighting a slight discharge of the battery, thickening of car oil and an increase in its viscosity. If you are the owner of an injection machine, you run the risk of "flooding" the candles.
Step 2
If after the first attempt to start the car, the engine does not start, do not try to force the car to move. Turning the ignition key every few seconds will make the situation worse. Take short breaks between attempts (about 30 seconds).
Step 3
In order to warm up the battery at least a little, turn on the dimensions or low beam. Within two minutes the car will feel better and, possibly, will start. But at the same time, pay close attention to the warming up of the battery. under heavy load, it will discharge very quickly. Then you can say goodbye to your cars for the whole day.
Step 4
When you try to start an injection machine in cold weather, do not press the gas pedal. Most cars of this type are equipped with a manual transmission, which will help you with this difficult work. In particular, press and release the clutch pedal just before starting. Using this method, the motor should start working from the second or third attempt.
Step 5
If this did not happen, do not despair. Switch off the ignition and open the hood. Check the battery connections (+ and - fields) carefully. Also check the condition of the candles. It is better to change this part on a regular basis. it wears out quickly and becomes unusable. In the event that everything is in order with the car, there is only one choice - to disconnect the battery and bring it into the house to warm it up. If you are in a hurry - ask another car owner to "light". To do this, put the spare battery cables in the trunk in advance. Always start joining with a "-" sign. Check the engine and go about your business.
