Winter is hard to bear not only by living organisms, but also by mechanisms, especially in the yard, the weather conditions, when at night the temperature drops to -30 degrees, and in the daytime it again becomes -5 - -10 degrees. For car owners, such sudden temperature fluctuations pose a lot of problems.
Necessary
- - filters replaced on time;
- - Replaced candles on time;
- - oil suitable for cars;
- - lack of water on the wiring and in the tank;
- - a working battery;
- - not damaged distributor and wires.
Instructions
Step 1
First, make sure that absolutely all electrical consumers are turned off: air conditioner, radio tape recorder, seat heating, oven fan, etc.
Step 2
In many ways, the battery's performance depends on its temperature, so turn on the headlights for a while, if it is cold, then the electric return of the battery will increase the flowing current and heat it.
Step 3
Don't start the engine right away, just crank it with the starter. This will allow the motor to turn easier the next time and ensure the oil flow.
Step 4
Now try the envy engine. At the same time, in order to facilitate the rotation of the crankshaft, do not forget to depress the clutch completely. There's nothing you can do about an automatic gearbox - just rotate the transmission. If you fail to start the engine, do not try again immediately, as the situation can be aggravated by accidentally filling the spark plugs.
Step 5
After 20-30 seconds, try again, most likely, in this case, the engine will start. Due to the automatic injection system, the required amount of mixture enters the cylinder, so do not press the gas pedal. Try several times, taking a break of 30 seconds, if the engine does not start.
Step 6
Proceed to the consideration of the following problems if 5-7 attempts were unsuccessful.
Step 7
Use WD-40 (special spray) to remove moisture from high-voltage wires. Due to condensation, it could well have formed there.
Step 8
If, due to a large number of unsuccessful attempts, the battery is discharged, ask for a light using the wires. At the same time, you provide a much higher voltage on the spark plugs, which means that the starter will turn the engine more intensively.
Step 9
If it was not possible to start the engine from the wires, then it remains only with the help of a rope. Arrange in advance about the signal at the moment when the car starts so that you do not have to drive around the area like this. Also, ensure that the vehicle does not drift from side to side with a clear straight line, this can be done by immediately engaging second or third gear. When the engine starts, immediately depress the clutch, disengage the gear and use the accelerator pedal to prevent the engine from stalling again.
Step 10
Warm up the engine by increasing the RPM with the pedal. With the idle system, only 800 rpm is maintained, which means that the engine will warm up much longer.
Step 11
Do not turn on the stove right away, let the engine warm up well for a start.
