Correct installation of a burglar alarm on your car increases the chances of protecting your car from theft and theft. It increases the chances, since there is no absolute protection: professional hijackers neutralize any protection and disable any alarm. However, the longer an attacker “digs” with the machine, the more likely he is to abandon his idea or switch to another object.
Necessary
A set of keys and screwdrivers, electrical tape, scotch tape, multimeter, alarm with instructions
Instructions
Step 1
A car burglar alarm must have the following minimum set of functions: block the engine, be triggered when doors, hood or trunk are opened, and have shock sensors. It is desirable to have additional functions: remote engine start and vehicle status monitoring using a key fob with a screen, the ability to program functions. Monoblock models are more compact and convenient to use. In spaced-out circuits, the components are installed in different parts of the car, which makes it difficult for the hijackers to disable the alarm. The large number of sensors included in the system increases its reliability. The tilt sensor will be triggered when you try to lift the machine. GSM / GPRS-module allows you to control the alarm by sending SMS from a cell phone and track the movement of a stolen vehicle.
Step 2
When choosing a security system, consider the storage conditions of the car. For garage storage or storage in a parking lot, a pager is required that transmits a signal to the key fob at a distance of 300-500 m. If the car is stored at the entrance, there will be enough siren. However, in case of false alarms, the remote control allows you to re-arm the system without leaving your home. It is believed that the cost of signaling should be 5-7% of the cost of the car. This is the best option.
Step 3
In the case of self-installation of the alarm, it becomes possible to invent and implement new possibilities for installing and placing blocks in the most unexpected places or slightly improve the blocking scheme. However, in order to properly install the system, knowledge and skills are required. Otherwise, there is a risk of damaging the on-board electronics or causing a short circuit. Remove all alarm mark logos. Place two sirens: one in an open place, hide the other. Both sirens must be self-powered. Fix the central unit under the front passenger seat, covering it with a metal sheet and placing it in a multilayer bag. Can be installed in any other place away from moving parts and sources of heat or moisture (for example, under the center console). Replace the multi-colored wires with the same and wrap the outlet of the wires with electrical tape. Mount the shock sensor (shock sensor) closer to the longitudinal axis of the vehicle. For example, in the lower right side of the dashboard.
Step 4
Starting a carburetor engine is already difficult, so there is no need for a complex engine blocking circuit. In injection models, the blocking circuit should include blocking the power supply of the ignition system, fuel pump, starter and / or sensors.
Step 5
If you are not confident in your abilities, install the alarm at the technical center, and then modify it yourself: mark the location of the units installation, replace the wires, etc.
