Almost every motorist wants his car to stand out in some way from the general range of cars of the same model. And the owners of domestic cars are no exception. It is quite possible to start improving your "horse" by installing fog lights on it.
Necessary
1.5 m steel wire with a diameter of 2-3 mm, terminals, Phillips screwdriver, pliers, key 10, electrical tape
Instructions
Step 1
Open the mounting block and unscrew the screws.
Step 2
Pull out and turn the case.
Step 3
Find the yellow and black-yellow wires in the S1 connector. Take three wires - black and yellow, yellow and yellow and black thin in the bundle from the connector.
Step 4
Open the hood and disconnect the wires from the fluid level sensor and washer reservoir.
Step 5
Unscrew the nut that holds the washer reservoir.
Step 6
Tilt the washer and, using a steel wire, pull them into the passenger compartment.
Step 7
Strip the wires, crimp both yellow wires with male terminals and insulate them.
Step 8
Connect the block.
Step 9
Connect the two yellow wires with a cable tie to the wire harness.
Step 10
Replace the washer fluid reservoir.
Step 11
Remove the screws holding the plugs under the hood of the car.
Step 12
Cut two pieces of wire 50 cm long each, crimp and secure to a hairpin
Step 13
Do the same for the second headlight.
Step 14
Use steel wire to run the wires along the wires in the front side member.
Step 15
Pull out both wires where the fog lamp mounts. Leave no more than 15 cm of wires and crimp on each ground.
Step 16
Put wide female terminals on the wires.
Step 17
Install the two threaded brackets to the bumper.
Step 18
Insert the bulbs into the headlights.
Step 19
Connect the black wire to the body and the yellow wire to the light bulb, put on the rubber cap.
Step 20
Install and screw on the fog lights.
21
Connect the relay.
22
Check the headlights.
The headlight installation is complete.
