How To Set The "Sher Khan" Timer

Table of contents:

How To Set The "Sher Khan" Timer
How To Set The "Sher Khan" Timer

Video: How To Set The "Sher Khan" Timer

Video: How To Set The
Video: Программирование пин кода для открытия машины без ключей 2024, July
Anonim

Signaling manufacturer "Sher-Khan" offers motorists a variety of modifications with a different set of functions. An undeniable benefit is the ability to set the Sher-Khan timer to automatically start the engine.

How to set a timer
How to set a timer

It is necessary

  • - signalization "Sher-Khan"
  • - instructions for signaling
  • - remote control to enable / disable engine start by timer

Instructions

Step 1

Study the instructions for your Sher-Khan alarm. The developer offers two types of launch at the time you want. With the first mode, the engine is started every day at a predetermined time. The second mode involves turning on the engine every 2 hours, if it is necessary to activate the heating or cooling system of the passenger compartment.

Step 2

Use the buttons II + IV on the key fob. Presses should be short and quick. Wait for the word “timer” to appear on the display - it serves as an indicator that the ability to start the engine by timer is activated.

Step 3

To program the timer to start the engine every day at a certain hour, press buttons II + IV and turn off the word “timer”.

Step 4

Enter the programming menu of the required functions using the II + III combination, holding it for 2 seconds. Press button II. The display will show the previously set time (range 24 hours).

Step 5

Using button I (pressing 0.5 seconds) select the desired hour, button II - minutes. Use the combination II + III to exit the programming mode of the alarm functions. Hold the buttons for about 2 seconds. To finish programming, use II + IV, turn off “timer”.

Step 6

When the engine starts by timer, you will hear one siren signal. Once the alarm will be triggered, the LED will produce signals corresponding to the STCTS. The headlights and the image of the lock will flash on the key fob display five times, the word “timer” will appear. The unit will emit one beep.

Step 7

If it is necessary to automatically switch on for heating / cooling the passenger compartment, use a single short press on buttons II + IV. No programming is required in this mode. The first start of the engine will take place after two hours.

Recommended: