If you decide to make noise insulation of the VAZ 2107 dashboard, then you must first remove it. This business must be approached extremely responsibly. The plastic elements of the panel are very fragile and can be easily damaged when removed.
It is necessary
- - Phillips screwdriver;
- - a screwdriver with a straight slot;
- - set of heads.
Instructions
Step 1
First, unscrew the mounting screws and remove the steering shaft cover. After that, remove the nozzles, which are designed to heat the side windows, and the ventilation nozzles on the instrument panel.
Step 2
Then, using a screwdriver, remove the plug, which stands for heated windshield. To remove the shield, you need to unscrew the screw that is located under the cap. Then you can disconnect the devices from the electrical circuit.
Step 3
The left and right speakers are hidden under the cladding. It must be removed. Please note that two plastic holders are installed along the upper edge of the claddings. Shoot them with extreme caution. They are very fragile.
Step 4
Each speaker is secured with 4 screws. Remove them with a Phillips screwdriver. Next, remove them from the panel and disconnect the wires. Now you can proceed to remove the shelf. To do this, remove the 3 screws. They are located below. You can immediately remove the glove box body.
Step 5
Then unscrew the nut of the daily speedometer and remove the cable from the dashboard counter. Next, pay attention to the radio mounting panel. Remove the watch, rear window defogger switch, and cigarette lighter from it. Disconnect all wires.
Step 6
Remove the radio receiver and disconnect it from the mains, having previously unscrewed the fastening screws. Pull gently on the top and remove the bottom radio mount. Unfasten the hooks of the upper insert and remove it from the panel.
Step 7
Next, squeeze from the inside all the hooks that are located in the upper part of the decorative panel insert. Take it out. Unscrew the four nuts of the upper fastening of the dashboard through the openings of the instrument glove box. Also, immediately remove the two bottom mounting screws. Remove the panel and insert. Collect the torpedo in the reverse order.
