Excessive savings of manufacturers of cars of the "tenth generation" in Togliatti, expressed in the installation of locars (wheel arch liners), which do not provide reliable protection against corrosion of body surfaces and empennage, forces the owners to replace them with tuning counterparts.
It is necessary
- - curly screwdriver,
- - 10 mm spanner,
- - sharp knife
Instructions
Step 1
Before purchasing a new set of protective wheel arch liners, carefully study and remember the location of the attachment points installed on the car locators.
Step 2
You should buy a kit with a similar mount - this will facilitate the work associated with installing new accessories.
Step 3
In those cases when it is not supposed to wash the wheel arches, the old wheel arches are dismantled and replaced with new locars. For this procedure, the wheels are not removed from the car.
Step 4
Front accessory installation begins with mounting the locking plate on the wheel arch liner, then it is placed in a recess above the wheel, and its outer edge is engaged with the wing flange. After that, two nuts are screwed onto the studs, and four fastening bolts are screwed to their places of destination. If some part of the fender liner does not adhere enough to the car body, it is additionally fastened with self-tapping screws.
Step 5
Installation of wheel arch liners over the rear axle wheels is carried out in a similar way.
