Buying a car, each owner takes care of it and considers his "swallow" the best. It is for your own car that good acoustic equipment is bought and fashionable tuning is done, which also includes such actions as installing alloy wheels or decorating wheels with branded caps.
Instructions
Step 1
Often, having installed caps on his car, the owner is faced with the problem of losing them right when the vehicle is moving. Surely many have noticed on the side of the road parts that have fallen off (caps). What to do in such situations, how to fix the caps so that they are not lost on the road, even at maximum speed on the highway or when overcoming obstacles in rural areas.
Step 2
First of all, we would like to note that wheel covers have two important functions - protective and decorative. So, the hubcaps reliably protect the wheel rims, especially in winter, from impacts of stones, mud, ice, snow, water, etc. and besides that they decorate the car with their exclusive look. That is why it is important that these devices are always on wheels, and for this it is necessary to perform a number of simple steps to fix the caps.
Step 3
Purchase a 300mm cable tie. You can buy such a screed at absolutely any computer store or radio parts store. Cable ties are sold in packs of 50-100 pieces. A small pack is enough for you.
Step 4
Install the purchased wheel covers on your car. Take out one cable tie. Pay attention to the lock connection that the tie has, it is this connection that allows you to fix a small twig (cable tie) in a ring and close it.
Step 5
Insert one cable tie into the hole in the hood and slide it in until it fits around the hole in the metal rim of the wheel. Make a loop around the disc and hubcap. Grab the other end of the tie with your hand.
Step 6
Connect the cable tie lock and pull until it is firmly pressed against the hood.
Use a pair of scissors or nail clippers. Cut off the excess screed piece.
Try to shake the cap, you will see that it is fixed firmly and securely.
Step 7
Hide the buckle fastener under the metal disc. To do this, you just need to turn the resulting loop clockwise or counterclockwise.
Ready. Step back and evaluate the work done visually.
We would like to draw your attention to the fact that it is not worth tightening the tie too tight, as it will rub the cap and over time an unwanted erased strip will appear on it.
