The capabilities of each car engine are limited, and sometimes the car owner wants to improve its performance. If there is an opportunity to contact a car dealership, then it is best to do just that. However, you can pump the engine yourself.
Necessary
- - supercharger;
- - filter of zero resistance;
- - balanced shaft;
- - connecting rods;
- - turbocharger.
Instructions
Step 1
Replace the existing air filter with a zero resistance filter. To do this, install an inlet receiver that could have a larger volume; it should also have the smallest intake manifold possible. After that, change the throttle valve to increase its cross section. Remember that the throttle body, manifold, carburetor, air filter, and intake air reservoir are integral to engine intake tuning.
Step 2
Increase the stroke of the cylinder bore and piston. This is necessary in order to enable the engine to accommodate as much air-fuel mixture as possible. These changes will contribute to an increase in torque, as well as slightly increase power.
Step 3
After that, tune the cylinder head (cylinder head), since this factor most affects the power and its increase. To tune the cylinder head, increase the cross-section of the manifold and channels of the cylinder block, the inner diameter of the valve seats. After that, replace the camshaft so that the valve can open with a greater amplitude. Replace the old carburetor with a better model. After that, contact a special auto repair shop to bore the cylinder block in order to avoid defects on its walls.
Step 4
Install a turbocharger in your car so that this design contributes to the creation of excess pressure directly at the engine intake by using the energy of the exhaust gases.
Step 5
Contact the wizard to correct the program responsible for the injection. This process is called chip tuning. It makes the car economical, easy to drive and more responsive. The savings reach one liter per hundred kilometers.
