The rear axle of a passenger car is kept from longitudinal and lateral movements relative to the car body by jet rods. The rods are attached to the brackets of the axle body and the supporting part of the body, therefore, any play formed in the places of these connections can lead to a road accident.
Necessary
- - 19 mm spanner,
- - 17 mm spanner,
- - drift,
- - a hammer.
Instructions
Step 1
Thanks to the original technological solution for the design of the fastening of the reaction rods, the rubber bushings absorb all the shocks that inevitably occur while the car is moving on roads with any surface. A simple unit at first glance, but how much comfort it brings to the control of the machine.
Step 2
Therefore, any play in the rear hub mountings is eliminated without delay. It must always be remembered that an unreliable rear suspension is the cause of many accidents.
Step 3
In order to replace the rear bushing, the thrust is dismantled from the machine, which is preliminarily placed on an inspection pit, overpass or lift.
Step 4
The thrust released from the fastening is clamped on a workbench in a locksmith's vice, after which, first of all, a metal sleeve is knocked out of it with a hammer and a punch, and only then a rubber insert is mercilessly removed from the thrust eyelet with a screwdriver, which in configuration resembles two truncated cones connected to each other.
Step 5
Further steps for assembling the machine are carried out in the reverse order.
