When driving in poor visibility conditions or at night, drivers often lack light. Xenon allows you to detect obstacles and hazards earlier, creating good illumination of the roadway.
Necessary
- - a flat area adjacent to the wall;
- - roulette
Instructions
Step 1
After making sure that the system is working correctly after installing xenon, fixing the ballasts on the car body, reinstall the headlights and fix it. Then you need to adjust the headlights.
Step 2
Find a horizontally flat area with a wall adjacent to it. Place your car as close to her as possible. Draw a vertical line on the wall opposite the center of the car. Then drive the vehicle back about seven meters from the wall.
Step 3
Take a tape measure and measure the distance from the lamp to the ground. If the optics are separate, that is, the main beam lamp is separated from the dipped beam lamp, measure for each lamp separately.
Step 4
Also find out what is the distance between the lamp and the center of the car. For separate optics, measure in the same way as in the previous step: separately for high and low beam lamps. Record all the values obtained.
Step 5
With chalk on the wall, draw a horizontal line, stepping back from the first measurement (distance from the lamp to the ground) 5 cm down. On this line from the center marked on the wall at the very beginning, draw two verticals at a distance equal to the result of the second measurement (between the lamp and the center of the car).
Step 6
For separate optics, additionally draw a horizontal line to a height equal to the result of the first measurement for the high beam lamp from the ground. Then, in accordance with the second measurement for the high beam, draw vertical lines on this line.
Step 7
Now that all the necessary lines are drawn on the wall, turn on the low beam and first adjust the headlights in a vertical plane. Make sure that the horizontal line of the headlights is flush with the horizontal strip.
Step 8
In the horizontal plane, adjust the headlights so that the point at which the light begins to "go" up, falls on the drawn intersection. Make the same settings for separate optics. Line up the high beam headlights along the top line, and the low beam along the bottom.