How To Replace The Pads

Table of contents:

How To Replace The Pads
How To Replace The Pads

Video: How To Replace The Pads

Video: How To Replace The Pads
Video: How to Change Front and rear Brake Pads and Rotors (Complete Guide) 2024, November
Anonim

The fact that the brake pads are in a critical condition is usually indicated by an unpleasant grinding of metal that appears at the moment of braking in the area of / u200b / u200bthe location of the front wheels. If you notice this symptom in your car, do not postpone replacing the brake pads, as otherwise it can lead to increased wear of the brake discs.

How to replace the pads
How to replace the pads

Instructions

Step 1

Replacing the pads is a simple task, to complete it you do not need any special tools other than a wrench to loosen the bolts. So hang out one front wheel and use a jack to install a support. Remove the wheel. Using a large screwdriver or spatula, spread the brake pads to their original position. Perform this procedure one at a time with each pad.

Step 2

After installing the brake piston in the initial position, unscrew the brake mounting bolt with a caliper towards the bushings. The brake caliper contains two similar bolts that secure the body. Select the mounting bolt that, after unscrewing, will allow the brake caliper housing to swing to the side. More often than not, the brake hose interferes. After moving the brake caliper to the side, rotate it on the guide pin. Take out the old brake pads and inspect them carefully. If you notice that one of the pads is more worn out than the other, then, probably, at the moment of braking, the brake caliper is seized.

Step 3

If you find that the guide bush boots are torn, be sure to replace them. Remember to put new grease underneath them. Usually complete with branded pads always have everything you need for replacement, including grease bags.

Step 4

After you have installed new brake pads, reinstall the tin pads. Don't throw them away thinking you don't need the parts. Put the brake caliper back on, screw the bolt back into place. Put back the wheel and spin it. Lower the vehicle from the jack.

Step 5

Do the same for the other side of the machine. After fully installing the brake pads, press the brake pedal several times. This is done in order to determine the ideal clearance between the pads, piston and brake disc.

Step 6

Remember, it's better to spend the money and get quality branded pads as otherwise you'll end up with quick brake pad wear.

Recommended: