How To Install An Alarm With Auto Start

Table of contents:

How To Install An Alarm With Auto Start
How To Install An Alarm With Auto Start

Video: How To Install An Alarm With Auto Start

Video: How To Install An Alarm With Auto Start
Video: How To Install an Alarm and Remote Start System 2024, November
Anonim

Remote start of the car engine from the alarm panel is an indispensable option in winter. It allows you to warm up the engine to the required temperature and sit in an already warm interior. In severe frosts (below 20C) with a weak battery, it will not work to start the car remotely. You can program an hourly timer that will start the car after a certain time on its own. This will keep the engine at the right temperature overnight to start without problems in the morning.

How to install an alarm with auto start
How to install an alarm with auto start

It is necessary

  • Drill
  • Screwdriver
  • Side cutters
  • Insulating tape
  • Tester or Continuity Tester

Instructions

Step 1

The main autostart wires are connected to the ignition lock - the starter wire (12V), ignition 1, ignition 2, ACC wire (in the first position of the key, 12V appears).

Step 2

If the car is equipped with a standard immobilizer, then an immobilizer module ("crawler") must be purchased in addition to the alarm. One of the ignition keys is inserted into the module. During remote engine start, information is read from this key and transmitted to the ignition lock.

Step 3

It is necessary to connect the engine start control wire to the alarm with auto start. It connects to an oil gauge, generator or tachometer.

Step 4

Program the alarm unit according to the instructions for this model. The main positions for programming: selection of engine start control, engine running time, automatic transmission or manual transmission.

Step 5

From the unit, connect the wire that goes to the brake or "handbrake". It is needed for emergency jamming of the car or resetting information on starting the engine.

Recommended: