Russian-made cars are distinguished by a relatively low price and unpretentious maintenance. And the latest models can quite compete with inexpensive foreign cars. An example is the Lada Priora. However, the owners of this model are often faced with the presence of noise in the car, which becomes very noticeable during long driving.
It is necessary
Soundproofing sheets, construction hair dryer, glue, sheet rolling roller, sealant, carpet or foam rubber
Instructions
Step 1
Carry out an audit in the car. Very often, a large number of unnecessary things accumulate, which, when driving, make unpleasant sounds when vibrated. For example, a small change casually thrown onto the dashboard rings very loudly. Items in the glove compartment may also clink. You can get rid of this by laying the bottom and walls of the glove compartment with foam rubber, carpet or other soft material.
Step 2
Window deflectors can also be a source of noise. They are designed to protect the vehicle from rain entering the vehicle through a slightly open window. But when driving, air enters the deflectors and creates air turbulences, which can cause whistling. Check how tight they fit against the top edge of the door. Over time, the glue can shrink and lag in some places. In this case, it is necessary to remove the deflectors, remove the old adhesive and apply a new one. It is worth remembering that a new layer of glue can only be applied to a dry and grease-free surface.
Step 3
Check the condition of the rubber bands. A leaky gum not only creates an unpleasant sound, but also allows air to pass through, so the interior of the car will cool down very quickly in the winter season. Purchase a new set of seals. It is relatively inexpensive. The replacement process is completely simple. You need to remove the old ones, clear the space under them and attach new ones.
Step 4
Find out if your car has soundproofing installed. Typically, the car has a soundproofing for the engine compartment as standard. If, while driving, you too clearly hear the operation of the motor, then it is necessary to replace the old noise insulation. To do this, you need to remove the torpedo. Underneath you will find a layer of silver color. Heat it up gradually with a building hair dryer and tear it off the car body. Remove any remaining adhesive backing. Gently glue the new layers of insulation, preheating it. Remember that no layer should remain in the air. Soundproofing must accurately fit all irregularities and protrusions. If desired, glue the floor, ceiling and doors as well.
Step 5
Check the operation of your audio system. At high volume, the speakers generate a lot of vibration, which can cause side sound effects. The speaker should fit snugly in its socket. To do this, insert sealing gum and apply a sealant to the joint. The subwoofer should be attached to a surface covered with soft, non-thick material.
