With the introduction of amendments to the law on the light transmission of glass, or rather to the established GOST 5727-88 “Light transmission of glasses providing visibility for drivers, must be at least: 75% for windshields; 70% for glasses that are not windscreens”, the question of removing the tinting arose sharply in order to avoid getting a fine. The average cost of rendering glass in a service station is 300-400 rubles. However, this procedure can be done independently and practically free of charge.
It is necessary
Razor blade, spray bottle water, towel, glass cleaner
Instructions
Step 1
With the corner of the blade, hook the edge of the film (from the inside of the glass). It is better to pick up from several sides at once for easier removal. Then, with sharp - frequent movements, begin to peel off the film from the glass. Along the way, spray water on areas of glass from which the film has already been torn off.
Step 2
After removing the film, glue remains on the glass. To remove traces of glue, we need a regular razor blade and water. Moisten the glass abundantly with water using a spray bottle. This is to reduce friction to avoid scratches. With light movements, applying the blade to the glass at an angle of 45 degrees, from the top edge of the glass towards the bottom, begin to remove the glue. Do not forget to wet the traversed areas along the way.
Step 3
After we removed the glue, we need to wipe the glass. Wipe the glass with a towel dampened with glass cleaner. This is necessary to remove glue residues from microcracks. Finally, dry the glass with another dry towel.
Carrying out this procedure yourself, you will save time by not standing in lines, and, just as important, money.
Good luck on the road!
