How To Make A Spray Booth

Table of contents:

How To Make A Spray Booth
How To Make A Spray Booth

Video: How To Make A Spray Booth

Video: How To Make A Spray Booth
Video: Airbrush Spray Booth Build 2024, November
Anonim

Surely all motorists know that after an accident, before painting, the car is first straightened. The car itself is painted in a special spray booth. The cost of such a camera is quite high, so not every car service can purchase such equipment. But at the same time, you can make a spray booth yourself.

How to make a spray booth
How to make a spray booth

It is necessary

  • - spacious garage;
  • - heat gun;
  • - heat generator;
  • - fan;
  • - cable (if there is not enough wiring);
  • - plastic lining.

Instructions

Step 1

Rent a spacious garage measuring approximately 4x6 meters. Before renting a garage, explain in detail the purpose of its appointment to the head of the garage cooperative. It may be necessary to run a separate cable, but sometimes existing wiring is sufficient.

Step 2

Find out if the machines and LED lamps have changed in the garage; if so, be sure to ask about their power. Don't take new garages. Keep as few people as possible in the garage so that there is as much air in the room as possible.

Step 3

Having established your own business, try to buy out not only this garage, but also the neighboring one, put a door and a window between them. In the second garage, after painting the car, it will be possible to position your workers, since drying sometimes takes a long time. The window will be needed to supervise the drying.

Step 4

Sheathe all the walls of the garage with plastic clapboard, preferably Russian-made, install several bulbs there, always daylight. In the upper part of the garage, it will be necessary to install a heat gun with additional heating elements, placing it so that the air passes from above through the duct at six points.

Step 5

Make a grate from fittings in order to raise the floor by 10-15 cm, and place a fan under the floor to extract air from the chamber.

Step 6

Install a heat generator on the diesel fuel for heating the heating elements, which will allow you to significantly save on electricity.

Step 7

Install infrared lamps and air dry the camera. This action will speed up the garage readiness process several times. And your spray booth is ready to use. You can also make such a camera from plywood or any other sturdy material, then its size will depend on your needs. If you make it large, then you will also have to increase the exhaust capacity, i.e. a regular fan will no longer work here.

Recommended: