If you want to tint the car windows with a film, you can always find a specialized car service that provides such services, but the real pleasure and pride of the work done is the self-pasting of your car. In addition, hard work will save the family budget.
Necessary
- - a roll of tint film,
- - blade or scalpel,
- - shampoo,
- - spray gun.
Instructions
Step 1
Hardworking motorists who prefer to make changes to the design of their own vehicle on their own should learn some of the professional secrets of gluing film on the side windows of cars.
Step 2
So that the quality of self-pasting glass is not inferior to professional pasting, glass intended for tinting is dismantled from the car and delivered to the bathroom of your home, where a hot water tap opens when the door is closed (water vapor will clear the surrounding atmosphere from flying dust).
Step 3
On a drawing board or other flat surface, patterns are cut out of the film, increased along the perimeter by 5 cm compared to the size of the glass. The film is cut with a blade, scalpel or sharpened knife.
Step 4
After putting aside the finished patterns, in the bath it is necessary to prepare an aqueous solution with the addition of a small amount of shampoo, and lay a drawing board on top of it, which it is advisable to cover with a bike blanket, in order to avoid the formation of scratches on the back surface of the glass being pasted during operation.
Step 5
After finishing the preparations, they start washing the glasses and, laying the clean glass on the board, the protective layer is separated from the pattern intended for gluing. During the current process, the film and glass surface are intensively sprayed with water from a spray bottle.
Step 6
By placing the film on the inner surface of the glass, it is smoothed out, and air bubbles and water residues are removed from under it. It is best to carry out this process with a small wooden ruler wrapped in cloth.
Step 7
After 6-8 hours, when the pasted glass is completely dry, around its perimeter, stepping back from the edge of about five millimeters, the excess tint film is cut off, after which the glass is installed in its place in the car.
