Gazelle refers to large vehicles capable of transporting a fairly large amount of cargo. However, the gasoline consumption of a Gazelle loaded to full capacity rises sharply in comparison with an empty car. Overruns are especially felt when traveling long distances. Therefore, it is advantageous to install a diesel engine to save fuel.
Necessary
- - new diesel engine;
- - diesel fuel;
- - set of tools;
- - winch;
- -Gazelle car service manual.
Instructions
Step 1
Weigh the pros and cons. The process of installing a diesel engine is a very laborious procedure. You will also have to make a lot of money. Therefore, it is necessary to make preliminary calculations in order to identify the approximate time frame in which this installation can pay off.
Step 2
Choose a diesel engine that is suitable for installation on your Gazelle. When choosing, you must first be guided by such aspects as the complexity of the installation and the demand for maintenance. A standard GAZ diesel engine can be purchased. Alterations in this case will be minimal.
Step 3
If you want more power from the engine, as well as maximum service life, then study the market for imported diesel engines. Consult with experts. When installing a new power unit, you must not make any changes to the design of the vehicle. Such innovations are illegal if there are no special papers, which can only be obtained through a series of complex examinations.
Step 4
Dismantle the hood by removing it from its hinges. This is the easiest way to remove the old motor and install a new one in its place. Disconnect the battery and all attachments. Read the instruction manual carefully before removing the standard engine. Visit the forum of Gazelle car owners. There you can get a ton of useful information on engine replacement.
Step 5
After disengaging and disconnecting all attachments, adjust the winch and run the belts under the engine mounts. Secure them carefully. Remove the engine mounting bolts. Disconnect the transmission from the power unit.
Step 6
Carefully lift the engine off the feet and pull it out from under the hood. Attach the new engine to the winch. Install new engine mountings in the engine compartment. It is best to take those that are used to install a new diesel unit.
Step 7
Use a winch to lower the new engine into the engine compartment. Try on the fasteners. Drill holes for new bolts if necessary. Secure the engine and remove the belts from under it.
Step 8
Start assembling and installing attachments in reverse order. Connect the gearbox to the engine and check if the connection is correct. Replace the entire fuel system, including the gas tank. Install new filters.
Step 9
Fill up with a full tank of diesel fuel and start the engine for the first time.
