The safety of the driver and his passengers directly depends on the quality and performance of the lamps. You can change the lamps yourself, spending very little time on it.
Instructions
Step 1
Remember that mostly Honda vehicles are equipped with headlights that combine low beam, high beam and direction indicators. Make sure that the bulbs are cool before replacing the bulbs. To do this, wait about half an hour after turning off the lighting devices, and then proceed to work.
Step 2
Open the hood and disconnect the cable from the negative battery clip. After that, squeeze the body of the protective casing and disengage it with the latch. If necessary, remove the engine coolant reservoir if it interferes with the procedure. Then turn anticlockwise the socket with the lamp you need and remove it.
Step 3
Pull the lamp towards you and remove it from the socket. If the wiring is suitable for the socket, then disconnect the connector. Remember that when installing a new lamp, do not touch the bulb with your bare hands. This can lead to leftover grease stains preparing premature failure of the lighting fixture. To prevent this, work with gloves, and if stains appear on the lamp, immediately remove them with a clean cloth and alcohol solution.
Step 4
After that, install the cartridge in the headlight housing and turn it clockwise until it stops. Make sure that it snaps into place firmly. Then plug in the electrical connector, secure the wire to the battery clip, and test the new lighting fixture to work.
Step 5
To replace the lamps of the internal lighting of the car, remove the cover, for this, carefully pick it up with a screwdriver, which must be previously wrapped with tape or electrical tape to prevent damage to the plastic case. After that, remove the lamp from the spring terminals of the holder and install a new lamp.
