How To Remove The Ignition Switch From A VAZ 2110

Table of contents:

How To Remove The Ignition Switch From A VAZ 2110
How To Remove The Ignition Switch From A VAZ 2110

Video: How To Remove The Ignition Switch From A VAZ 2110

Video: How To Remove The Ignition Switch From A VAZ 2110
Video: Broken Ignition Switch, Struck Steering Lock, Ignition Barrel Removal BMW E34 замок зажигания 2024, November
Anonim

On a VAZ-2110-2112 car, an ignition switch (lock) of type 2110-3704005 or KZ-881 is installed with an anti-theft locking device, blocking the re-engaging of the starter without first turning off the ignition and with a socket illumination. Removal and disassembly of the ignition lock is carried out when it is repaired or replaced.

How to remove the ignition switch from a VAZ 2110
How to remove the ignition switch from a VAZ 2110

It is necessary

  • - keys and heads;
  • - screwdrivers and pliers;
  • - hammer and chisel

Instructions

Step 1

Prepare the vehicle for operations. Remove the key from the ignition switch. Disconnect the negative battery cable. To do this, simply loosen the terminal fastening nut with a wrench and remove the wire. It is not necessary to remove the positive wire from the battery terminal.

Step 2

Remove the steering wheel, steering column trim and steering column switch assembly. To do this, use a Phillips screwdriver to unscrew the four bolts securing the steering column trim and unscrew the three screws screwed into the steering column bracket. Push the steering column adjustment lever all the way down and remove the lower cowl. Then lift the lever all the way up and remove the top cover.

Step 3

Disconnect the connector for the wires coming from the steering column switch assembly. To remove the right steering column switch, squeeze the clips (top and bottom) with your fingers and remove it. Remove the left steering column switch in the same way. To remove the steering column switch connector, loosen the pinch bolt using the socket head, disconnect the horn wires and remove the connector itself.

Step 4

To remove the steering wheel with a flat-blade screwdriver, pry the horn button cover and remove it. Then use a Phillips screwdriver to unscrew the two screws securing the steering wheel cover and remove the cover. Then remove the moving contact of the sound signal by unscrewing the three screws of its fastening and disconnecting the wire

Step 5

Using a 24 socket head, unscrew the steering wheel mounting nut. In this case, do not remove the nut completely. In a rocking motion, pull the steering wheel towards you to remove it from the shaft. If it breaks off the shaft, the unremoved nut will protect the person from injury. If the steering wheel is very tight, ask the assistant to pull the steering wheel. At the same time, simultaneously strike with a hammer through a drift made of soft metal on the end of the steering shaft.

Step 6

Disconnect the steering wheel slip ring wire. Then remove the ring itself by unscrewing the three screws of its fastening with a Phillips screwdriver. Then remove the steering column switch block interlocked with the ignition switch (lock).

Recommended: