How To Install An Anti-theft System On A VAZ

Table of contents:

How To Install An Anti-theft System On A VAZ
How To Install An Anti-theft System On A VAZ

Video: How To Install An Anti-theft System On A VAZ

Video: How To Install An Anti-theft System On A VAZ
Video: Как подключить сигнализацию 2024, December
Anonim

If you do not trust the technical centers to install the anti-theft system on the car, you can install it yourself. But in this case, you must have basic knowledge of car electrics, because any unskilled intervention can lead to unpleasant consequences.

How to install an anti-theft system on a VAZ
How to install an anti-theft system on a VAZ

Necessary

  • drill;
  • - screwdriver;
  • - side cutters;
  • - tester;
  • - insulating tape.

Instructions

Step 1

Purchase a simple alarm system with a minimum of necessary functions: a shock sensor, central locking control, engine blocking, a sound detector (siren), door, trunk and hood limit switches.

Step 2

Before installation, make the wiring from the alarm unit as shown in the diagram in the installation instructions.

Step 3

Find the place where you will hide the alarm box. This can be the space under the dashboard, behind the glove compartment, under the glove box. In any case, the block should not be in a conspicuous place and quickly be discovered and retrieved.

Step 4

Run the wires from the LED to the block along the side post. Fix the LED itself on the side or in the middle of the dashboard.

Step 5

Attach the shock sensor. Adjust the sensitivity of the sensor after the complete installation of the entire system when testing the alarm. The adjustment is made by a special regulator on the sensor itself. If the alarm key fob has an LCD display with feedback, you can adjust the sensitivity of the sensor directly from it.

Step 6

Various locks play an important role for the safety of the car. In total, you can make up to ten breaks in chains. But usually no more than three locks are made: ignition, starter, gasoline pump. The standard alarm kit includes a relay for only one blocking.

Step 7

Connect all wires to the alarm unit as shown in the installation instructions. In order to find out if there is a plus on the wire, use a tester or a dial tone.

Step 8

To connect the central lock, if it is not included in the vehicle, purchase electric drives that are installed under the door trim and connected to the unit, according to the diagram.

Step 9

Additionally, to enhance protection, put a "secret". "Sekretka" can break the circuit in the ignition or starter, but turn off using a special toggle switch or button and work autonomously from the security system.

Recommended: