There are often times when the driver loses the car keys or slams the door, leaving them inside. But this situation is completely solvable. Opening a car without a key, namely a Gazelle, is not so difficult as it might seem at first glance.
Necessary
- - one thin screwdriver;
- - thin, easily bendable wire.
Instructions
Step 1
To begin with, try to slightly lower the glass with your hands. If you succeed, then insert a thin screwdriver into the resulting crack in order to slightly widen the slot. Do this very carefully, because if you do not calculate the forces, you can ruin the car window.
Step 2
Measure a piece of the required length from the common coil of wire (so that the end of the wire reaches the locking button) and cut it off. At the end, make a loop with a diameter slightly larger than the diameter of the button. This is necessary so that the wire can easily be put on the blocker.
Step 3
Next, push the wire with a loop at the end into the resulting gap between the glass and the door and put it on the blocking button. You may not be able to do it the first time, so be patient and try to "catch" the button again and again until you achieve the result.
Step 4
Grasping the blocker with the loop, pull it up so that the wire can tighten around the button, thereby pulling it upward. As soon as the button comes out of the slot to a sufficient level, your door will immediately open.
Step 5
In the event that the glass does not go down, try pushing the window inward, carefully bending the seal with two thin screwdrivers. Broken glass can serve as an extreme measure, which will be easier for you to replace than others.
