To flank the wheel is not as difficult as it seems. You do not need to carry the wheel to the tire service, you can do all the work yourself. There are some simple rules.
Instructions
Step 1
Hang up the wheel first. To do this, you can substitute sticks under the pendulum. If possible, use a special motorcycle stand. A regular stool or plastic glass box will also work. If you decide to install a new rubber, then carefully inspect it. Some tires have a wheel direction icon. When boarding, you need to orient it correctly.
Step 2
Pay attention to the protector. It can also have direction. Consider this point. Then get on with removing the wheel. As a result, you should have a wheel with old rubber and a new tire in front of you for subsequent installation. To work, you must lay the newspaper on the floor. Seals and bearings must be free of dirt and dust. Otherwise, the mechanisms may fail during operation. You can also lay leatherette on the floor.
Step 3
After that, unscrew the spool and bleed the air that is in the wheel. If the wheel has plastic caps, it is best to replace them with metal ones. They are more reliable. Next, you need to separate the tire from the rim. To do this, simply walk on it.
Step 4
After the circle has separated, use the edgers to flip it over the edge of the rim. It is recommended to start from the side opposite to the spool. Do not damage the camera near it. In the process, you must step on the back of the tire. Its edge should go deep into the rim. It will be much easier to disassemble the wheel.
Step 5
Disassemble the wheel halfway. Then carefully pull out the camera. Examine it carefully. There should be no damage or abrasion. If everything is fine with the camera, then put it aside. If there is serious damage, then replace it with a new one or repair it.
Step 6
Then flip the other bead over the rim edge. Inspect the rim tape carefully. There should be no gaps on it. Also, it should not be knocked to one side. This tape protects the camera from being punctured by protruding needles.
