Today, the VAZ 2112 car is very popular among motorists due to its low price, as well as its rather modern design. Like any other car, "dvenashka" requires timely replacement of low and high beam bulbs, as well as front turn signal bulbs. This procedure is simple, so it is more advisable to do it yourself in order to save on maintenance.
It is necessary
- - cotton gloves;
- - crosshead screwdriver.
Instructions
Step 1
Shift into neutral and lock the vehicle with the parking brake. Switch off the ignition and remove the keys from the lock. Open the hood and disconnect the minus terminal from the battery connector to prevent a short circuit. The best place to replace is in the garage. If not, then any place under a canopy will do.
Step 2
Purchase a set of new lighting elements. Use only bulbs of the brand recommended by the manufacturer. The installation of light elements from a third-party manufacturer is highly discouraged, as in this case you risk the technical health of your machine.
Step 3
Find the black rubber plug that gives you access to the high beam bulb. Detach it carefully and remove it from the slot.
Step 4
Pull gently on the terminal block attached to the lamp and disconnect it.
Step 5
Find the spring-loaded retainer. Pull it carefully out of the grooves. Remove the lamp from the socket. Examine it carefully. If the bulb explodes, all debris must be carefully removed from the socket.
Step 6
Install the new bulb in reverse order. In the same way, replace the high beam bulb on the second headlight.
Step 7
Replace the low beam bulbs in both headlights. Follow the exact same principle. The difference will be in the hole through which the lamps are replaced - it is located next to the hole for replacing the high-beam lamps.
Step 8
Remove the four screws holding the cover to replace the front turn signal bulb. Detach the cover itself. Grasp the bulb holder and gently turn it counterclockwise until it stops. After that, the bulb holder can be removed.
Step 9
Unscrew the bulb counterclockwise from the socket. Insert a new light element in its place and install the holder in the reverse order. After that, connect the battery terminal and check the functionality of the new lamps.
