In order to install xenon light on "Prior", choose the most suitable set of lamps for you. To get brighter and closer to white light, focus on a color temperature of 5000 K. Prepare everything you need for installation.
Instructions
Step 1
Start by removing the headlights. Open the hood, then unscrew the headlight fixing screw. Use a long screwdriver to unscrew the two clips of the headlamp housing with a long screwdriver, then remove it from the installation slot. Disconnect all wires from the headlamp housing. Disconnect the large terminal with a flat, small screwdriver. To do this, insert it from the wire side into the small slot on the terminal and slide it over the edge of the handle. While doing this, press the screwdriver against the wire. Be careful not to damage the plastic catch by carefully removing the terminal. The latch open signal is a rise in front of the lug terminal.
Step 2
Choose a place for attaching the ignition unit to the car body under the headlight housing in order to secure the unit. The holes for the mounting screws are already provided at the recommended location. Fasten the unit so that the unit does not rest against the metal bumper when installing the case.
Step 3
Locate the four wires inside the cover that supply power to the removed standard bulbs. Note that the brown wires are negative and the white wires are positive. Note that xenon bulbs may have different wire colors, where black is positive and blue is negative. Connect the terminals according to the polarity, put the xenon lamp in its original place, and clamp it with a latch. Close the cover so as not to pinch the wires. Connect the terminals to the ignition unit.
Step 4
Repeat all the operations described for the second headlamp, install them in the niches. Check their functionality by connecting the power terminals. Secure the headlights if inspection indicates correct installation. When installing the headlights, make sure that the body fits strictly into the installation grooves. Further, after docking the guides, push the headlight in the direction of the passenger compartment so that a characteristic click appears, which indicates the closing of the latches. Close the hood only after tightening the fastening screw.
